RF10MCB-WSW1 - Substitute Carbon Post-Filter for Kitchenaid Part # 4396163, 4396547, 8212491

The RF10MCB-WSW1 10 micron filter uses Extruded Carbon Block Technology encapsulated inside of a Proprietary Plastic Housing to reduce or remove Chlorine, Hydro-Carbon Gases, Sediments and other debris from untreated water. Small granules of Bituminous Carbon are crushed and molded into long solid Blocks of Carbon and then cut to specific lengths. Ammonia, Chloramines, VOC’s, Sediment, Silt, Clay, and Bacteria pass through this filter because of the Carbon used and larger micron rating. This filter provides reasonable protection against Chlorine and Hydro-Carbon Gas contaminants, and is better suited for Bath, Kitchen, Bar, or Island Sink Faucets and Shower Heads, as a Pre-Filter for a multistage Reverse Osmosis system, or as a Pre-filter for Tubs, Tanks, Pitchers, etc. This filter utilizes a Proprietary design which restricts the consumer to only one choice of filter cartridge selection and one distribution entity when replacing expired or exhausted filters, which typically imposes a higher retail price and compromise in quality and performance.

Recommended Service Interval on Most Water Supplies: 6 Months